Filter
Top Products
4
❑
TD-6V (Percussion Sound Module) x 1
❑
KD-8 (Kick Trigger Pad) x 1
❑
FD-8 (Hi-Hat Control Pedal) x 1
❑
PDX-8 (V-Pad) x 1
❑
PD-8 (Pad) x 3
❑
CY-5 (Cymbal Pad) x 1
❑
CY-8 (Cymbal Pad) x 2
❑
Connection Cables
❑
Tuning Key x 1
■
TD-6KW Owner’s Manual x 1
• The tuning key is included in the FD-8 package.
• The TD-6V Owner’s Manual is included in the TD-6V
package.
• This package does not include a kick pedal. Use with a
commercially available kick pedal.
• This package does not include the CY-5 attachment set
for cymbal.
962a
* In the interest of product improvement, the specifications and/
or appearance of this unit are subject to change without prior
notice.
Assemble the Drum Stand.
About the Stand, refer to the owner’s manual for the
stand.
Attach the mounting plate (included with the optional drum stand) to the TD-6V.
Using the screws attached to the bottom panel, attach the holder so the unit is oriented as shown in the diagram.
fig.TD-6V.e
• To attach the stand holder, remove the four 8 mm
screws (M5 x 8) from the bottom of the TD-6V and
use them. Use of other screws may result in
damage to the unit.
928
• When turning the unit upside-down, get a bunch
of newspapers or magazines, and place them
under the four corners or at both ends to prevent
damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or
controls get damaged.
929
• When turning the unit upside-down, handle with
care to avoid dropping it, or allowing it to fall or
tip over.
Checking the Contents of the
Box
Drum Stand
TD-6V
(Percussion Sound Module)
Narrow
Wide
TD-6KW_e 4ページ ２００６年１月２４日 火曜日 午後６時３分