Rolls MX34c DJ Equipment User Manual


  Open as PDF
of 4
 
DESCRIPTION
FRONT PANEL
c
HEADSET
MIC
1/8”
MIC1 and MIC2
LEVEL: Adjusts the amount of signal of the indicated Microphone channel.
PAN: Adjusts the relative level of signal from the channel to the Right/Left Output.
pwr: When lit, indicates that the MX34c is on. A dim light indicates low battery
voltage.
HEADPHONE
LEVEL: Adjusts the amount of signal from the Headphone Output.
OUTPUT: 1/8” (3.5mm) jack containing the Headphone Output signal.
REAR PANEL
12 VDC
+
CHANNEL
1
CHANNEL
2
INPUTS
POWER
STEREO
OUT
AUX
IN
OUTPUT LEVEL
MIC
LINE
INPUTS: 1 - 2: XLR balanced inputs for connection to any standard dynamic or condenser
microphone. The input circuitry has a very wide input range and can accommodate almost
any (mic to line) level signal.
AUX IN: Tip-Ring-Sleeve stereo 1/8” (3.5mm) jack for connecting to another line-level
stereo signal source.
STEREO OUT: Tip-Ring-Sleeve stereo 1/8” (3.5mm) jack for connection to a camera or
other stereo input.
MIC/LINE OUTPUT LEVEL: Button for switching the stereo output level to MIC or LINE.
Follow the silk screening of the unit for switch
orientation.
POWER: Button applies power to the MX34c.
12 VDC jack: For connection to the Rolls PS27
12VDC power supply.
BATTERY INSTALLATION: To replace the 9 V alkaline batteries, fi rst carefully press in
and up on the door to release the battery compartment. It then slides out and you can
replace the battery. Remember to replace both batteries at the same time.
PHANTOM POWER: Follow the silk screening of the MX34c to activate phantom power to
the input XLR’s.
SCHEMATIC
2
5
 previous