Rolls MX44S Music Mixer User Manual


  Open as PDF
of 2
 
INTRODUCTION
Thank you for your purchase of the MX44s 4 Channel Stereo Mixer. This
unit is designed to mix up to four stereo line-level signals such as instru-
ments, CD players, DVD players, MP3 players, laptop computers, etc. to
a single stereo output.
WARRANTY REGISTRATION
For complete warranty information, please visit our website at www.rolls.
com and click on the "Register Your Warranty Here" text, and follow the
link and instructions.
DESCRIPTION
REAR PANEL
OUTPUTS: 1/4" and 1/8' (3.5 mm)Tip-Ring-Sleeve jack for connection to
a mixer input, amplifier or other input device.
ON/OFF: Latching push button switch for applying power to the MX44s.
12 VDC: Power jack - connects to the Rolls PS27 AC adapter.
BATTERY: Removable compartment for housing a 9 volt alkaline battery.
TOP PANEL
pwr: LED - Indicates that the MX44s is connected to a power source, and
the unit is on.
1 - 4: Volume controls - adjust the level of the signals coming from Inputs
1 - 4.
FRONT PANEL
IN 1 - 4: 1/4" and 1/8" (3.5mm)Tip-Ring-Sleeve stereo unbalanced jacks
for connection to line level devices.
OPERATION
To connect various devices to the MX44s, you'll need the proper cables.
- Connecting most CD, Cassete, and Video units will require a stereo RCA to
stereo 1/4" or 1/8" (3.5mm) cable. A stereo plug consists of tip, ring and sleeve
connections - shown in Fig. 1.
- Most stereo instruments have individual Right and Left outputs. Therefore, you'll
need an "Insert" type cable. This cable has two 1/4' TIp-Sleeve jacks on one end
to connect to the stereo instrument, and a Tip-Ring-Sleeve stereo jack on the
other end to connect to the MX44s. For assistance on cable selection, contact
your local professional audio dealer.
- Some devices have stereo 1/4" outputs identical to the inputs of the MX44s.
These devices will require a 1/4" TRS stereo to 1/4" or 1/8" TRS stereo cable.
NOTE: PLUGGING A TIP-SLEEVE MONO PLUG INTO THE MX44s WILL NOT
DAMAGE THE UNIT. HOWEVER, THE SIGNAL WILL BE HEARD ON ONLY
THE LEFT SIDE. DO NOT PLUG A MONO JACK INTO EITHER OUTPUT
- THIS WILL DAMAGE THE UNIT.
TO SEND A MONO SIGNAL TO THE MX44s, USE A TRS JACK WITH THE TIP
AND RING CONNECTED TOGETHER.
While the MX44s is not a headphone amplifier, the outputs have sufficient level
drive a pair of headphones or earphones for limited monitoring.
SCHEMATIC
Tip - Ring - Sleeve
Fig. 1
 previous