Filter
Top Products
5
Using the Optional SP01 “Spider” Shock-Mount
THREADED
COLLAR
SP01
SHOCK MOUN
T
THUMB
SCREW
THREADED
COLLAR
Using the Optional SP01 Shock-Mount
1
2
For additional isolation the C01 can be fit-
ted on the optional SP01 “Spider” shock
mount. Follow the steps below the to
install the SP01.
• First, screw the SP01 shock mount
onto your mic stand or boom arm. If
you’re using a US 5/8” mic stand or
boom, remove the Euro adapter.
• Remove the C01 swivel mount by
rotating the threaded collar counter-
clockwise as shown in figure 1.
• Install the C01 into the SP01 by fitting
the microphone into the center of the
web, positioning the C01 onto the bot-
tom mounting plate.
• Secure the SP01 by reinstalling the
threaded collar, rotating clockwise
until tight. (Figure 2)
•Now, loosen the thumb screw to
adjust the angle of the microphone
and position the C01 to the desired
location. Once set, tighten the thumb-
screw to secure the microphone in
place.
Note:
Be careful not to cross thread
or over tighten the threaded collar or
thumb screw.
ENGLISH