19
Specifications
Maximum Output Level
(0.5% T.H.D at 1kHz)
+24dB(MAIN L/R) @10k +20dB(GROUP, AUX/EFX, CTRL ROOM) @10k
+20dB(INSERT) @10k More than 100mW(HEADPHONES) @33
T.H.D
<0.1% @+14dB 20Hz ~ 20kHz (MAIN L/R, GROUP, AUX /EFX SEND) @10k
Frequency Response
20Hz ~ 20kHz, +1/-2dB (MIX L/R, GROUP, AUX /EFX SEND) @10k
-128dBu
equivalent input noise ( Rs=150 )
-95dBu
Residual noise (MAIN L/R, MONO, MAIN B, GROUP, AUX ,EFX OUT)
-83dBu
MAIN, MONO, GROUP * Master fader at nominal level and all channel fader
Minimum.
Hum and Noise
Input GAIN=Maximum
Input sensitivity
-50dBu
-76dBu
AUX Master control at nominal level and all channel control Minimum.
Maximum Voltage Gain
74dB MIC IN TO MAIN L/R, GROUP, MONO
66dB MIC IN TO AUX (PRE)
76dB MIC IN TO AUX (POST) / EFX SEND
52.2dB MIC IN TO REC L/R
54dB LINE IN TO Main L/R, GROUP, MONO
46dB LINE IN TO AUX (PRE)
56dB LINE IN TO AUX (POST) / EFX SEND
44dB ST IN TO MAIN L/R, GROUP, MONO
16dB AUX RETURN IN TO MAIN L/R
27.8dB TAPE IN TO MAIN L/R
Crosstalk (at 1kHz)
-70dB between input channels
-70dB between input/output channels (CH INPUT)
Gain Control(mono Input
Channel)
44dB Variable (-50dB ~ -6dB), (-30dB ~ +14dB)
Gain (stereo Input CH)
40dB Variable (-20dB ~ +20dB)
High Pass Filter
75Hz, 18 dB/Octave
Input Channel
Equalization
HIGH: 12kHz shelving 15 dB
MID : 100~8kHz peaking 15 dB
LOW: 80Hz shelving 15 dB
Input Channel
Equalization
HIGH: 12kHz shelving 15 dB
HI- MID : 3kHz peaking 15 dB
LO-MID : 500Hz peaking 15 dB
LOW: 80Hz shelving 15 dB
LED Meters
12-point LEDx2 MAIN L/R, PFL/AFL,GROUP(1~4)
2 x 24 BIT DSP, 100 selectable presets
Internal Digital Eects
FOOT switch (ON/OFF)
Channel Indicators
Peak: An indicator for each channel turns on when the pre-channel fader signal is 5dB
below clipping.
Phantom Power
+48V DC
USB Bus Power
+5V DC 0.5A max USB A-TYPE FEMALE
Power Source/Power
Consumption
AC 120V/230V/240V, 50/60Hz L2400:60W, L3200: 75W
Weight
L2400 : 35.6 lb. (16.2kg), L3200 : 40 lb. (18.1kg)
Dimensions
L2400 : 31.5” (W) x 21” (D) x 6.25” (H) / 798(W) x 533(D) x 162(H)mm,
L3200 : 40.4” (W) x 21” (D) x 6.25” (H) / 1014(W) x 533(D) x 162(H)mm
Where 0dBu= 0.775V and 0dBV=1V
Measured with 12.7kHz, -6dB/oct. low pass lter