Filter
Top Products
12
Top Panel Controls
7. FX Auxiliary Control (MXP124FX) - The channel’s FX knob controls the
amount of signal that is sent to the effects bus. The signal of the FX bus
in the MXP124FX is routed to the Digital Effects section for on-board
signal processing. The FX signal can also be sent to an external effect
device connected to the FX SEND jack located on the front panel jack
field.
MON Auxiliary Control (MXP124) - Controls the amount of that channel’s
signal that is sent to the MON Output. The signal feeding MON is sent
before, or pre, the channel fader, so the channel fader has no effect on
the MON level. The MON is usually used to create a separate mix for a
floor monitor system.
8. PAN Control - The PAN control is used to place or position the mono signal
into the stereo main left and right mix bus. You can create a stereo image
by panning some input signals to the left and others to the right.
9. PEAK Indicator - This LED indicator will flash red when the channel input
signal peaks. To reduce distortion, turn the GAIN control counterclockwise
until the clip indicator does not light during normal use.
10. Volume Fader - The VOLUME Fader control adjusts the level of each mono
input channel.