Filter
Top Products
58
Specifications
Mixer / Pre Amp Section:
1. Frequency Response (± 1 dB) 20 Hz - 20 kHz
2. Total Harmonic Distortion (20 Hz to 20 kHz, trim minimum) 0.02%
3. Maximum Voltage Gain
Mic to Post EQ Main Insert L,R +64 dB
Mic to Aux Send 1,2 +74 dB
Mic to Mono Out +54 dB
Line to Post EQ Main Insert L,R +44 dB
Stereo to Post EQ Main Insert L,R +24 dB
Aux Return to Post EQ Main Insert L,R +10 dB
Tape In to Post EQ Main Insert L,R +24 dB
4. Residual Noise (with DIN audio filter)
All Fader Min / Post EQ Main Insert L,R -90 dB
All VR Min / Aux Send 1,2 -90 dB
Ch Fader Min, Master Fader Max -75 dB
5. Equivalent Input Noise (-50 dB, Mic In pins 2,3 150 Ω,with DIN audio filter.) -127 dB
6. Crosstalk (@ 1 kHz, Trim Min.)
Channel to channel -70 dB
Input to output -70 dB
7. EQ Control
High (10 kHz) ±15 dB
Mid (1.8 kHz) ±12 dB
Low (100 Hz) ±15 dB
8. Graphic Equalizer
(63 Hz, 160 Hz, 400 Hz, 1 kHz, 2.5 kHz, 6.4 kHz, 15 kHz) ±12 dB
9. Phantom Power +48 V
10. Signal Polarity (Phase) same as Input
Power Amp Section:
1. Maximum Output Power (0.5% THD @ 1 kHz) 150 W / 4 ohm
2. Total Harmonic Distortion (20 Hz to 20 kHz, 1/2 rated power) 0.2%
3. Frequency Response (1 W/4 ohm, ±0.5 dB) 20 Hz - 20 kHz
4. Signal To Noise Ratio > 100 dB
5. Channel Separation 75 dB
6. Output Offset Voltage ± 100 mV
General:
1. Dimensions
(W x D x H) 491 x 349 x 139 mm
19.35 x 13.75 x 5.5 in
2. Weight 29.7 lb • 13.5 kg
3. Power Requirements 115 V ac 60 Hz for UL and CSA Version
230/240 V ac 50/60 Hz for BSI and Central Europe Version
100 V ac 50/60 Hz for Japan Version
4. Power Consumption 780 w