Filter
Top Products
-4-
D3012–D3016 Wood Clamp Hardware Kit Instructions
5. Insert the four dowel nuts into the holes
drilled in Step 2, making sure the left-hand
threaded dowel nuts go into the positions
shown in Figure 6.
6. Evenly thread each end of both threaded
rods into the dowel nuts, as shown in Figure
7, until enough rod is exposed to slide the
handles all the way over the rods.
7. Drill two
1
⁄8" holes completely through the
handles and the threaded rods, as shown in
Figure 8.
Standard
(Right-Hand)
Threaded
Dowel Nuts
Reverse
(Left-Hand)
Threaded
Dowel Nuts
Figure 6. Inserting dowel nuts.
Standard
Threaded
Section
Fully Threaded
Rod
Rod with
Unthreaded
Section
Reverse
Threaded
Section
Figure 7. Inserting threaded rods.
Drill Holes for
Handle Pins
Figure 8. Drilling holes for handle pins.
8. Insert a handle pin through each handle and
threaded rod, support the head of the pin
from beneath, then use a small hammer to
mushroom the exposed end of the handle
pin, as shown in Figure 9, to prevent it from
falling out.
Congratulations—construction and assembly of the
clamp is complete!
Round Over
& Flatten
Handle Pins
Support Block
Figure 9. Inserting handle pins.