Filter
Top Products
TRANSISTORIZED BASE STATION MICROPHONE
GENERAL
The Shure Model 526T Series II SUPER PUNCH
base
station microphone is designed for clearer transmission and
improved reliability. This transistorized microphone can be
used to replace ceramic or dynamic, high- or low-impedance
microphones supplied as original equipment.
Model 526T Series II provides crisp, undistorted voice re-
sponse with adjustable volume control for optimum intelligi-
bility of transmission.
The microphone is designed for maximum versatility in
base station operation. It has a momentary or locking press-
to-talk transmit/receive switch for greatest ease of use, and
a modulation level volume control for highest undistorted
output with high- or low-impedance inputs. The supplied six-
wire cable and triple-pole double-throw switch are arranged
for universal microphone-transceiver connection.
The microphone is not affected by heat or humidity, and it
is oustanding in its ability to resist mechanical shocks and
vibration. Its exclusive ARMO-DUR
case is immune to oil,
grease, fumes, salt spray, sun, rust, and corrosion. The “Mil-
lion Cycle” leaf-type press-to-talk switch is designed to with-
stand rigorous operating conditions and constant use.
Microphone Features:
S Dynamic microphone with transistorized preamplifier
S Adjustable volume control for optimum transmiter
modulation and maximum intelligibility
S Replaces either ceramic or dynamic original equip-
ment microphones
S Excellent response for single-sideband transmission
S Uses readily available 9-volt battery—low current
drain for long life
S Low hum pickup, minimum susceptibility to RF inter-
ference
S Momentary or locking press-to-talk transmit/receive
switch –”Million Cycle” leaf-type
S Universal six-wire cable for instant microphone-trans-
ceiver connection
S Sturdy, high-impact ARMO-DUR
case
S Rugged and dependable under all operating
conditions
BATTERY INSTALLATION
Model 526T Series II uses a 9 Vdc battery (90AJ1371).To
install the battery, proceed as follows:
1. Loosen two screws (located underneath base) holding
battery retaining clip, and remove battery retaining
clip.
2. Connect terminal strap to battery.
3. Insert battery in VELCRO strap of battery retaining
cllip and fasten VELCRO strap.
4. Insert battery retaining clip in base and tighten screws
securely.
CONNECTIONS
Model 527T Series II can be connected to an input (trans-
ceiver, transmitter, or amplifier) of 500 ohms or more. For de-
tailed instructions for connecting the 526T Series II to CB or
ham transceivers. If your unit is not listed in the Guide, con-
tact your dealer or Shure Incorporated for information.
A piece of tubing is attached to the plug end of the cable
for use as a strain relief for plugs with large cable entry holes.
Remove the tubing when not required.
The internal connections of Model 526T Series II are as
shown in Figure 1.
Model 526T Series II Super Punch
Microphone User Guide
27B1468 (AI)
2001, Shure Incorporated
Printed in Mexico