Filter
Top Products
ENGLISH ENGLISH
– 7 –
Changing the UC1 Transmitter Battery
1. Make sure the transmitter power ON/OFF switch is in the OFF position.
2. Open the transmitter battery compartment by squeezing the two tabs on either side of the transmitter. Then flip the
battery cover down. Refer to Figure 6.
3. Lift up on the edge of the battery remove it.
4. Insert a new 9V battery in the compartment. Maintain proper battery polarity (”+/–”).
CHANGING THE UC1 TRANSMITTER BATTERY
FIGURE 6
Changing the UC2 Transmitter Battery
1. Make sure the transmitter power ON/OFF switch is in the OFF position.
2. Unscrew the battery cover.
3. Pull down on the old battery and remove it. Refer to Figure 7.
4. Install a fresh 9V alkaline battery. Make sure the battery terminals match the terminals in the transmitter. Screw the
battery cover back into place.
CHANGING THE UC2 TRANSMITTER BATTERY
FIGURE 7