Filter
Top Products
11
TRANSMITTER SETUP
Transmitter Battery Installation
Open the battery cover and insert a fresh 9V alkaline or lithium battery, as shown in Figure 20.
FIGURE 20
ULX1 Bodypack Connections
If you are using a Bodypack system with a Shure lavalier microphone or instrument adapter, plug the microphone
cable or instrument adapter cable into the transmitter input connector, as shown in Figure 21.
NOTE: The wiring of the input connector on the transmitter is designed for Shure microphones.
FIGURE 21
Turning the Transmitter On
NOTE: DO NOT turn on the transmitter before powering up the receiver. Once the receiver has located an
open frequency, turn the transmitter on and set it to that receiver frequency. Turning the transmitter
on rst will interfere with the receiver’s frequency scanning function.
1. Slide the transmitter ON/OFF switch to the ON position, as shown in Figure 22. The power LED will momentarily glow
red, then change to a steady green. The default frequency setting (Channel 1, Group 1) will appear on the display.
FIGURE 22
1.
1.