Filter
Top Products
6
GB
Getting Started
What cords will I need?
Audio cord (not supplied) (1) (for the amplifier powering
the front speakers)
What cords will I need?
Speaker cord (not supplied) (1 for each rear speaker and one
for the centre speaker)
Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
Hookups
Front speakers
Rear and centre speakers
Active woofer
Processor
LINE
AUDIO
IN
L
R
PRE OUT
L
R
Red (R)Red (R)
White (L)White (L)
(+)
(+)
(–)
(–)
Rear speaker
(R)
Centre speaker
Rear speaker
(L)
Processor
} ]
} ]
} ]
SPEAKERS
REAR
LR
CENTER
45°
60 - 90 cm
Rear
Front
FRONT OUT
REAR SPEAKERS
CENTER SPEAKERSSURROUND
REAR/CENTER out
SURROUND
MIX out
Control Amplifier
Processor
LINE
AUDIO
IN
L
R
LINE OUT
L
R
L
R
FRONT
OUT
AUX
INPUT
L
R
Processor
Amplifier
(for front speakers)
CD Player (etc.)
Hookups
The arrow ç indicates signal flow.
Audio system
Connect the PRE OUT, ADAPTER OUT, or TAPE REC jacks
on your control amplifier to the LINE IN jacks on the
processor.
CD player (etc.)
Connect the LINE OUT jacks on your CD player (etc.) to the
LINE IN jacks on the processor.
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the processor. Although you can connect rear and
centre speakers directly to the processor, front speakers
must be connected through a separate amplifier (as
shown below). Connecting an active woofer will
increase bass response.
For specific locations of the terminals, see the
illustration below.
For optimum surround sound effect, place your
speakers as shown below.
Processor
Active woofer
REAR
SURROUND
MIX
CENTER
INPUT