Filter
Top Products
22
System Configurations and Speaker Connections
•Delay
SYSTEM TYPE 6: Select when no compensation is
necessary.
SYSTEM TYPE 7: Select when the distance between the
front speakers and the satellite speakers are 5 meters to
8 meters (16.7 feet to 26.7 feet).
SYSTEM TYPE 8: Select when the distance between the
front speakers and the satellite speakers are 8 meters to
11 meters (26.7 feet to 36.7 feet).
SYSTEM TYPE 9: Select when the distance between the
front speakers and the satellite speakers are 11 meters
to 14 meters (36.7 feet to 46.7 feet).
Details on the contents of SYSTEM TYPE
preset pattern settings
• MIC INPUT Low Cut Filter (common to all SYSTEM
TYPE preset patterns)
Cutoff frequency: 100 Hz, –12 dB/oct
• INPUT MUTING (common to all SYSTEM TYPE
preset patterns)
Default setting: OFF
• OUTPUT LINK
In the AV system incorporating stereo speakers, the
level of the L channel and the R channel links and the
ouput level of the L and R channels is equal to each
other.
• COMPRESSOR (common to all SYSTEM TYPE preset
patterns)
• REMOTE FADER
Depends on the SYSTEM TYPE preset patterns.
For details, refer to SRP-X500P Manager User’s Guide.
To change the preset settings, set the SYSTEM TYPE
selector to “0,” and make each setting on the SRP-X500P
Manager program.
To suppress howling
By using the FEED BACK REDUCER buttons, you can
suppress howling by detecting the frequency bands in
which the howling may occur, and then reducing the gain
of those bands through the 5-band equalizer.
To detect the frequency bands in which
howling may occur in order to suppress
howling
Make settings on the microphone and the SRP-X500P to
suppress howling more effectively.
1
Set the reference level for the microphone.
While talking on the microphone in a normal voice,
adjust the TRIM control so that the REF. indicator
lights intermittently.
Note
When you use a wireless microphone, adjust the
attenuator on the microphone instead of the TRIM
control.
2
Adjust the volume on the SRP-X500P.
Set the input level control and the MASTER control
to 0 dB position.
3
Set up the microphone.
Place the microphone where it is used and adjust the
direction.
4
Adjust the speaker output.
Turn up the SPEAKER OUT control on the SRP-
X500P slowly until the speaker output reaches the
level to be heard from anywhere within the place. Be
sure to turn down the SPEAKER OUT control whose
corresponding speaker output is not used fully to –
∞
dB.
5
Perform the howling suppression.
Keep pressing the FEED BACK REDUCER button
on the SRP-X500P for the corresponding MIC
INPUT connector for 2 seconds or more.
The button indicator flashes as the SRP-X500P scans
the frequency bands.
When the button indicator stops flashing and lights
up, howling suppression is completed.
Notes
• While the SRP-X500P is scanning the frequency
bands, the sound similar to howling may be output.
If the output sound is too loud, press the FEED
SPEAKERS
SP 1 SP 2 SP 3 SP 4
SYSTEM TYPE 6 ON/OFF OFF OFF OFF OFF
TIME 0ms 0ms 0ms 0ms
SYSTEM TYPE 7 ON/OFF OFF OFF ON ON
TIME 0ms 0ms 34.6ms 34.6ms
SYSTEM TYPE 8 ON/OFF OFF OFF ON ON
TIME 0ms 0ms 40.4ms 40.4ms
SYSTEM TYPE 9 ON/OFF OFF OFF ON ON
TIME 0ms 0ms 52.0ms 52.0ms
FUNCTION ON / OFF ON
THRESHOLD 10dB
RATIO
∞ : 1
ATTACK 0. 47ms
RELEASE 100ms