Filter
Top Products
Selectable Options
The eight channel Monitor Sends are factory set as POST
FADE, but may be altered to PRE FADE in blocks of four (1-4
and 5-8) by repositioning a link on the Input PCB SC3005 as
shown below, after removing the PCB from the console.
R56
R54
J1
J3
J3
J1
PRE
PRE
PRE
PRE
J2
J4
J4
J2
POST
POST
POST
POST
INPUT BOARD SC3005
R48
R55
C21
C28
C27
R51
R50
R47
R45
R44
L9
To change Sends 1-4 to PRE FADE carefully unsolder link J4
using the minimum of heat to avoid the possibility of tracks
lifting on the PCB. Replace the link in position J3.
To change Sends 5-8 to PRE FADE carefully unsolder link J2
using the minimum of heat to avoid the possibility of tracks
lifting on the PCB. Replace the link in position J1.
This operation should only be carried out by competent
technicians who possess the necessary soldering skills.
Page 25