Filter
Top Products
Removing a fader:
1. Make sure mixer is powered off and power supply is disconnected from
back of mixer.
2. Remove the fader to be cleaned or replaced by unscrewing the 2 outer
screws on the fader plate (removing the 2 inner screws will detach the
fader from the fader plate).
3. Disconnect the fader from mixer by removing the connector on the
bottom of the fader.
Installing a fader:
1. Once original fader has been removed, simply plug the 4-pin
connector into the new fader.
2. Place fader back in mixer and replace 2 outer screws to secure fader.
After constant use the faders may need to be cleaned and lubricated
from time to time. This will ensure long life and keep a smooth feeling
throughout the fader's lifetime. Follow the instructions below to lubricate
and clean your faders:
FADER CLEANING AND INSTALL