Filter
Top Products
PAGE 20 — MQ STOW MS15H/MS15E MIXER — PARTS & OPERATION MANUAL — REV.FINAL (08/10/06)
MS15H/MS15E MIXER — INSPECTION
3. Insert and remove the dipstick without screwing it into the filler
neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 8), fill to the edge of the oil filler
hole with the recommended oil type (Table 7). Maximum oil
capacity is 2.33 qts. (1.09 liters)
Reference manufacturer engine
manual for specific servicing
instructions.
Figure 8. Engine Oil Dipstick (Oil Level)
Before Starting
1. Read
all safety instructions
at the beginning of manual.
2. Clean the
mixer
, removing dirt and dust, particularly the
engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
ALWAYS wear approved eye and
hearing protection before operating
the mixer.
NEVER place hands or feet inside the
engine guard cover while the engine is
running. ALWAYS shut the engine down
before performing any kind of maintenance
service on the mixer.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Eyesight and Hearing
Protection
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Inspection &
Maintenance Saftey
epyTliO.5elbaT
nosaeS erutarepmeT epyTliO
remmuS rehgiHroC°52 03-W01EAS
llaF/gnirpS C°01~C°52 02/03-W01EAS
retniW rewoLroC°0 01-W01EAS
Figure 7. Engine Oil Dipstick (Removal)
2. Remove the filler dipstick from the engine oil filler hole
(Figure 7) and wipe it clean.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
NEVER operate the mixer in a confined
area or enclosed area structure that
does not provide ample
free flow of air
.
Respiratory Hazard
Failure to understand the operation of the WM-120 series
mixers could result in
severe damage
to the mixer or
personal injury
.
See Figure 5 for the location of any control referenced in
this manual.
WARNINGWARNING
WARNINGWARNING
WARNING
Explosive Fuel
Hazard
NOTE