Filter
Top Products
TASCAM LM-8ST
5
POWER switch and indicator
Press to turn power ON or OFF. The POWER indicator
lights when the power is ON.
MIC/LINE switch
Set whether the input source for channel 1 is the
microphone input or the line input.
MIC trim knob
Use this to adjust the microphone input level.
MIC input connector
Use this balanced XLR connector for microphone input.
Overload (OL) indicator
This lights if the level input to this device is too high
(overloading with a clipping level of –3 dB or higher).
Signal (SIG) indicator
This lights when a signal (–20 dBu or greater) is
detected at the input connector.
ST 2/AUX knobs
Use these to adjust the levels sent from each channel to
the ST 2/AUX bus.
ST 1 knobs
Use these to adjust the levels sent from each channel to
the ST 1 bus.
Output level meters
The top segment of each 4-segment output level meter is
an overload indicator.
MONO buttons
Push in to set the output to monaural.
LEVEL knobs
Use these to adjust the output levels.
ST 1, ST 2/AUX switch
Set which output to use for headphone monitoring.
Set it to ST 1 to monitor the ST 1 bus signal or ST 2/
AUX to monitor the ST 2/AUX bus signal.
PHONES knob
Adjust the headphones output level.
PHONES jacks
Connect headphones to these 1/4-inch (6.3 mm) and
1/8-inch (3.5 mm) jacks.
Front panel
2 − Names and Functions of Parts