Filter
Top Products
29
UTILITY
set by the Mix parameter in each block and “Input/Output”
will mute the direct signal at preset change.
Extern Modifier Input
This function sets how externally controlled parameters
should react at preset change.
Reset -
Will preset the controlled parameter to the value
stored in the preset. At the first movement of the External
controller, the parameter will be captured.
Preserve -
Will preserve the value of the external controller,
meaning that the controlled parameter will start this value.
Example: You are about to load a preset with an external
expression pedal controlling the Delay mix parameter. The
Delay mix parameter is stored at 50%. Now you load this
preset. If you selected “Reset” in the Ext. modifier input,
the Delay mix will be reset to the preset value=50%
If you selected “Preserve” in the Ext. modifier input, the
Delay mix will preserve the pedal value=100%.
Environment
Pedal
Type
Switches between momentary and alternating. This
parameter should be set to alternating if you are using an
expression pedal.
Pedal Calibration
Press Enter to enable calibration of the External input jack
on the back panel of the G-Force. Follow the instructions in
the display.
Pedal Curve
The response curve of the External 1/4” jack Input can now
be adjusted. After the External Input is calibrated, select
“Pedal Curve” in the “Utility - Config display”, and press
ENTER. Use the VALUE wheel to change the response
curve. Press EXIT to leave the “Pedal Curve” display.
The “Pedal Curve” parameter is global, and is therefore not
changed with presets.
T
uner MIDI Out
In the Utility menu, a Tuner MIDI Out parameter is added.
This parameter should be set to “On” to utilize the Tuner-
display function in a connected G•Minor pedal.
The Tuner MIDI Out parameter MUST be set to Off
when performing a MIDI Bulk dump.
If MIDI Out is connected to another device than a G-
Minor it may be advisable to use the “off” position to
avoid sending inappropriate MIDI information to that
device.
User Bank Protect
Protect
Sets the Protect function On/Off.
Protect Low limit
Sets the lower limit of the preset protect. The current
number is included in the protect.
Protect High limit
Sets the higher limit of the preset protect. The current
number is included in the protect.
User Bank Backup
You can backup the User presets of the G-Force to a card
or MIDI recording device using these functions.
Card type: SRAM PCMCIA, type 1, min. 64 K byte.
Depending on the size of the PCMCIA card sveral banks
on a single card is available.
User Bank to Card
Insert a PC-card in the Card slot and press Enter twice. All
User presets of the G-Force will then be saved to the
memory card.
Card to User bank
Insert a PC-card containing your presets and press Enter
twice. All presets will now be stored back into the User
bank of the G-Force.
WARNING: This action will overwrite ALL User presets.
User bank to MIDI
Connect your G-Force’s MIDI out to another G-Force, a
sequencer or any other MIDI recordable device. Press
Enter twice and the G-Force will perform a MIDI bulk dump
of all User presets.