Tektronix 8.00E+03 Drums User Manual


 
Reference
80E00 Electrical Sampling Modules User Manual
25
Overview Control elements & resourcesTo take a TDR measurement (cont.)
Take automatic
measurements
16. Use the Vertical buttons to select the TDR waveform to
be measured.
17. Select one of the measurement tool bars.
.
18. Click the measurement you want (such as mean)
in the measurement tool bar.
19. Read the results in the measurements readout.
20. To take your measurement over a portion of the
waveform, select the Region tab to display the gate
controls. Click the check box as indicated at the right
to turn gating on and to display the gates on screen.
21. Use the G1 (Gate1) and G2 spin controls (or click and
type i n values, use the keypad or multipurpose knobs,
or touch and drag the gate) to adjust the gates on
screen such that the area to measure is between the
gates.
If necessary to provide a good view of this porti on of
the waveform, adjust the Vertical SCALE and
POSITION and the Horizontal SCALE, POSITION,
and Reference. To see the difference scale and
position can make in your waveform display, compare
the waveforms in Figure 15 and also compare the
waveforms in Figures 12 and 13.
Gate G1 Gate G2
Check to
display gates
Vary to
position gates
Access to virtual keyboard