The Singing Machine STVG-502 Karaoke Machine User Manual


 
D Warning - Tapping or dropping the microphone while it is on can permanently damage
your microphone. Resist the urge to swing the microphone around by the cord!
PREPARATION
! This unit is designed to play CD’s bearing the identification logo "". If CD’s do not
conform to the CD standard, they may not play properly.
! Fingerprints and dust should be carefully wiped off with a soft cloth. Wipe in a straight motion
from the center of the disc to the outside edge.
! Never use chemicals, such as record cleaning sprays, antistatic sprays or fluids, benzene or
thinner to clean compact discs. These chemicals will permanently damage the plastic
surface of the disc.
! Always place the compact disc on the disc tray with the label facing upward. Compact discs
can be played on only one side.
! To remove a disc from its storage case, press down on the center of the case and lift the disc
out, holding it carefully by the edges.
! Discs should be returned to their cases after use to protect them from dust and scratches.
! To prevent warping the disc, do not expose it to direct sunlight, high humidity or high
temperatures for extended periods of time.
! Do not apply paper or write anything on either side of the disc. The inks used in some felt-tips
pens may damage the surfaces of the disc.
PLAYING CD OR CD+G DISC
Reminders:
! Adjust MASTER VOLUME control on your unit, TV or audio system to a comfortable level.
! Adjust MIC/ECHO/BALANCE controls as needed to achieve the desired mix of music and
vocals through your TV or sound system.
! Do not press the disc cover of the CD compartment while it’s playing.
! Never place anything except a compact disc on the disc tray. Foreign objects can damage
the unit.
! Do not apply excessive force to disc cover.
! Only place one disc on the disc tray at a time.
TURNING POWER ON/OFF
! To turn on the Karaoke center, press the ON/OFF button, the ON/OFF LED will light up.
! To turn off the system, press the ON/OFF button again, the ON/OFF LED will turn off.
(Refer to the Trouble Shooting Guide on page E14 if a disc is loaded but the total tracks
do not appear.)
FUNCTION SELECT
Set the FUNCTION SELECT switch to CD+G.
LOADING A DISC
! Press the CD door OPEN button to open the CD compartment door. Place a disc in the
compartment with the printing side facing upward and the shiny side facing down.
! Press the CLOSE point (for CD door) again to close the CD compartment. The LED window
will display total number of track. (If no disc is loaded, it will display “ ”.)
CD OR CD+G OPERATION
E11
ENGLISH