Filter
Top Products
TROUBLE SHOOTING GUIDE
16
No song lyrics appear
on TV screen.
Connect the video cable to the
Singing Machine’s VIDEO OUT
and to the TV VIDEO IN.
Using your TV remote to select
VIDEO input. (Refer to page E8
under Common ways to configure
your TV or VCR)
Video cable is not connected
properly to the TV.
Source selector on TV is not
set to VIDEO.
Connect from VIDEO OUT of the
system to the VIDEO IN of your
VCR or connect to an RF
Modulator and then to the TV
cable input. Refer to “Making the
Connections” on page E7.
Check the disc to be sure it is a
CDG. (See page E18 for details.)
Check disc to be sure it is clean.
(See page E14 for cleaning
instructions.)
A CDG is loaded but the
CDG indicator is not lit.
TV does not have video line
input.
SOLUTION
PROBLEM
POSSIBLE CAUSE
Follow directions on page E7 for
“Making the Connections”.
No sound - If audio is
going through TV or
VCR.
Source Selection on TV or
VCR is not correct.
AVC is activated to
Maximum.
Adjust AVC to Minimum.
Balance is not adjusted
properly.
Adjust balance to mid point.
While playing CDG and
singing with the
microphone, the music
or vocal cuts out.
Playing music only track.
Play track that includes music and
vocal.
VERTICAL HOLD Control is
not set correctly.
Adjust the VERTICAL HOLD
Control.
Picture is jumping up.
The Camera Lens is down.
Lift up a Camera Lens.
No image display on
Singing Machine’s
monitor when attempting
to use camera.
MONITOR Selector is not
set properly.
Set MONITOR Selector to
CAMERA mode.
Image is blurry.
Camera has not warmed up.
Camera lens is dirty.
Wait a minute for the camera to
warm up.
Clean the camera lens.
Camera lens is out of focus.
Adjust the lens of the camera by
slightly rotating either left or right
until the display is clear. Do not
overturn the lens.
Lens cap is on. Remove lens cap.