Filter
Top Products
8
Note: All connections are made using standard loudspeaker cable.
Basic connection
The diagram below shows the basic connection of your unit to a
CD player and a turntable and a pair of loudspeakers.
Connections
Loudspeakers
Check the impedance of your speakers. When using a pair of speakers,
you can use types with an impedance of between 4 and 8 Ohms.
The red coloured speaker terminals are positive (+) and the black speaker
terminals are negative (-). Make sure correct polarity is maintained at
each speaker connector or the sound can become weak and “phasey”
with little bass.
Using bare wire connections
Prepare the speaker cords for connection by stripping off approximately
10mm (3/8”) or less of the outer insulation. More than 10mm could
cause a short circuit. Twist the wires tightly together so there are no loose
ends. Unscrew the speaker terminal, insert the speaker cable, tighten the
terminal and secure the cable.
LR
MP3 / Aux CD Tuner / DAB Phono BD / DVD Rec Out
MP3 / Aux
CD
Tun er / DA BPhono
BD / DVD
Rec Out
Right
Left
Right
Left
LeftRight
Loudspeaker Terminals
Impedance 4–8 ohms
Power AC
Ground
AM10
Right
speaker
Left
speaker
CD player
Red
Black Red Red Black
Black
RedBlack
Turntable