Filter
Top Products
REAR PANEL
@4POWER SWITCH
@5AC POWER JACK
Connect to the AC-12 adaptor.
@6MASTER OUT JACK(UNBALANCE)
Parallel out of P.A.output. Connect with the input of
power amp.
@7MASTER OUT JACK(BALANCE)
Parallel output of LINE output, Connect with the
input of power amp.
@8BALANCE OUT LEVEL SWITCH
Used to select output level
@9SUB MASTER OUT JACK
SUB MASTER output jack. Connect to input of
power amp as monitor in DJ booth or as a separate
sound zone for entrance foyer,etc.
#0REC OUT JACK
Output for recording. Connect with the input jack of
the tape deck. Also use for sub output when you need
the output beside main output. Pre-fader constant
level output. INPUT FADER (
!4) and MASTER
OUTPUT LEVEL (
!9) does not effect level.
#1CUE OUT JACK
The signal selected by CUE SWITCH and MASTER
CUE SWITCH is mono output. It can be sampled by
connecting to the input of any sampler without
hearing over the P.A. constant level output.
MASTER OUTPUT LEVEL does not effect level.
#2LINE INPUT JACK
Input connector for line level equipment such as CD
players, tape decks.
#3PHONO INPUT JACK
Input jack for each PGM turntable. Connect turntable
equipped with MM pickup cartridge only.
#4GROUND TERMINAL
Connect this terminal to ground lead of turntable.
This helps to reduce noise and hum.
#5MIC EFFECT LOOP SEND JACK
Connect to the input of external effects.
#6MIC EFFECT LOOP RETURN JACK
Connect to the output of external effects.
#7MIC INPUT JACK
Input jack of MIC.
POWER
AC IN 12V
LINE 4
+4 0 -10(dB)
LINE 5
R
L
R
L
R
L
R
L
RL
R
L
RL
PGM 4
MASTER SUB MASTER
REC OUT
BALANCE OUT LEVEL
PIN 1
PIN 2
PIN 3
GND
HOT
COLD
CUE OUT
GND
LINE 3 PHONO 3
PGM 3
GND
LINE 2 PHONO 2
PGM 2
GND
LINE 1 PHONO 1
PGM 1
MIC 1
MIC 2
MIC 3
SEND
RETURN
MIC
MIC1,2 EFF
LOOP
INPUT
MADE IN CHINA UNDER LICENCE
OFVESTAX TOKYO,JAPAN
SERIAL NO.
AC 12V 600mA
WARNING;SHOCK HAZARD-DO NOT OPEN.
AVIS;RISQUE DE CHOC ELELCTRIQUE -NE PAS OUVRIR.
CAUTION
RISK OF ELECTRIC
SHOCK. DO NOT OPEN
24 2628 29 31 35
3632 34302725
3733
7