Filter
Top Products
5
PROGRAM INPUT SECTION
1
8
9
10
2
3
4
5
6
11
7
5
EQUALIZER
(MID 1KHz +6dB -24dB)
Adjusts the MID frequeny level of each PGM
channel.
6
EQUALIZER
(LOW 80Hz +6dB -24dB)
Adjusts the LOW freguency level for each PGM
channel.
7
EQ CUT SWITCH ( HI, MID, LOW )
Cuts off the each frequency range by 24dB. The
EQUALIZER volume dose not function when this
switch is set to "CUT".
8
EFFECT SWITCH
Used to send the signal to the external effect processor
connected to the effect SEND/RETURN.
9
P.F.L.. SWITCH
Used to send the signal from the PGM channel to the
monitor section for headphone monitoring.
10
OVERLOAD INDICATOR
Lights when input level is over.
11
INPUT FADER
This is a detachable fader for the ease of
replacement. Replace with IF-175 when it is worn
out.
12
CROSS FADER
When the input level of PGM1 and PGM2 are
properly set, PGM1 will be heard with the cross
fader set to the left side. PGM2 will be heard with
the cross fader set to the right side. When the cross
fader is set in the center, both programs will be
heard. This is detachable fader for the ease of
replacement witrh "CF-PCV" when it is worn out.
1
INPUT SELECTOR
Used to select input (2 line or 1 phono) to be sent to
each PGM channel.
2
TRIM CONTROL
Adjusts the input level of each channel. Set INPUT
FADER to 7-8 position, adjust the TRIM CONTROL
so that the sufficient signal is fed without distortion.
3
BALANCE CONTROL
Adjusts the stereo balance for each PGM channel.
Can be used for adjusting the unbalanced stereo
image. Clockwise rotation from center position
increases the volume of R over L channel. A counter
clockwise rotation increases the volume of L
channel over R.
4
EQUALIZER
(HI 10Hz +6dB -24dB)
Adjusts the HI frequeny level of each PGM channel.