Filter
Top Products
7
FCC Information cont.
1. To ensure the finest perfor-
mance, please read this man-
ual carefully. Keep it in a safe
place for future reference.
2. Install your unit in a cool, dry,
clean place - away from win-
dows, heat sources, and too
much vibration, dust, mois-
ture or cold. Avoid sources of
hum (transformers, v mo-
tors). To prevent fire or elec
trical shock, do not expose to
rain and water.
3. Do not operate the unit up
side-down.
4. Never open the cabinet. If a
foreign object drops into the
set, contact your dealer.
5. Place the unit in a location
with adequate air circulation.
Do not interfere with its
proper ventilation; this will
cause the internal tempera-
ture to rise and may result in
a failure.
6. Do not use force on switches,
knobs or cords. When mov-
ing the unit, first turn the unit
off. Then gently disconnect
the power plug and the cords
connecting to other equip-
ment. Never pull the cord
itself.
7. Do not attempt to clean the
unit with chemical solvents:
this might damage the finish.
Use a clean, dry cloth.
8. Be sure to read the “Trouble
shooting” section on common
operating errors before con-
cluding that your unit is faulty.
9. This unit consumes a fair
amount of power even when
the power switch is turned
off. We recommend that you
unplug the power cord from
the wall outlet if the unit is
not going to be used for a
long time. This will save elec-
tricity and help prevent fire
hazards. To disconnect the
cord, pull it out by grasping
the plug. Never pull the cord
itself.
10. To prevent lightning dam-
age, pull out the power
cord and remove the
antenna cable during an
electrical storm.
11. The general digital signals
may interfere with other
equipment such as tuners
or receivers. Move the
system farther away from
such equipment if interfer-
ence is observed.
NOTE:
Please check the copyright laws in
your country before recording from
records, compact discs, radio, etc.
Recording of copyrighted material
may infringe
copyright laws.
Voltage Selector (General
Model Only)
Be sure to position the voltage
selector to match the voltage
of your local power lines before
installing the unit.
110V