Filter
Top Products
11
SWITCHING CHANNELS
With either the CH1 or CH2 LED lit, press the CH switch. The channel will change each
time you press the button, and the program stored in each channel will be recalled. (The
physical settings of the top panel selector knobs and control knobs are ignored at this
time.)
HINT: If the optional VFS2 dual foot switch is connected to the rear panel, you can
use it to switch programs. For details, refer to “Using the VSF2 dual foot switch”
(page 16).
HINT: If you want to bypass the effect, press the BYPASS button. If the BYPASS LED
is lit, there is no effect. To turn the effect on, press the BYPASS button once to turn off
the LED. The AD15VT, AD30VT, AD50VT, AD100VT & AD100VTH remember the
bypass setting even if you switch modes or programs, or turn off the power.
MANUAL MODE
When the AD15VT, AD30VT, AD50VT, AD100VT or AD100VTH is in Manual mode, it
works just like a non-programmable guitar amp. In other words, the positions of all top
panel selectors and knobs (except for the EDIT 1 knob) indicate exactly what you’re hear-
ing.
GETTING TO MANUAL MODE
If the MANUAL LED is dark, you’re not in Manual mode. Press the MANUAL button; the
MANUAL LED will light, and you’ll be in Manual mode.
NOTE: If the CH1 or CH2 LED is blinking (i.e., when you’re in the middle of selecting a
writing-destination for the program), the MANUAL LED won’t light when you press the
MANUAL button the first time. In this case, simply press the MANUAL button once again.
NOTE: In Manual mode when you edit parameters that aren’t defined by a knob setting
(i.e., effect parameters or noise reduction settings), those settings are saved automati-
cally, and will be recalled the next time you enter Manual mode. However if the EFFECTS
selector is at a different position than it was when you were last in Manual mode, the
default settings for that effect type will be loaded.
HINT: If you want to bypass the effect, press the BYPASS button. If the BYPASS LED is
lit, there is no effect. To turn the effect on, press the BYPASS button once to turn off the
LED. The AD15VT, AD30VT, AD50VT, AD100VT & AD100VTH remember the bypass set-
ting even if you switch modes, programs, or turn off the power.Creating and storing your
own program