Filter
Top Products
6
IMPEDANCE Select switch2.
16 OHMS: Combos allow for the following confi gurations;
Set it to this if you use the internal speakers only.•
Set it to this if you connect an external 16 Ohm speaker cabinet through the External jack.•
8 OHMS: Combos allow for the following confi gurations;
Set it to this if you connect an extension cabinet through the Extension jack. You’ll be run-•
ning the internal and external speakers in parallel. The impedance of the extension cabinet
must be 16 Ohms.
Set it to this if you connect an external 8 ohm speaker cabinet through the External jack.•
FOOTSWITCH jack3.
This is where you connect the included (VFS1) footswitch so you can
switch in and out of ‘macho’ mode.
MAINS INPUT connector4.
This is where the supplied, detachable Mains (power) cord is con-
nected.
NOTE! Use only the power cable that is included with the TB35C1/
TB35C2. Using another power cable may cause malfunctions.
The specifi c mains input voltage rating that your amplifi er needs to run at is located on the rear
panel of your amplifi er. Before making any connections or powering up the amplifi er, make sure
the correct voltage is set. If you have any doubt, refer to your local VOX dealer.
Specifi cation
TB35C1 TB35C2
Controls Volume (preamp), Bass, Mid, Treble, Reverb, Master volume, Bass
Boost, Macho (footswitchable), Master Volume Bypass
I/O Guitar Input High and Low, External speaker out, Extension speaker out,
Footswitch input
Tube Complement 4 x ECC83/12AX7, 1 x 12AT7, 4 x 6V6
Output Power 35Watts RMS
Speaker(s) 1 x 12” 16ohm Celestion G12-65 2 x 12” 8ohm Celestion G12-65
Dimensions (W x D x H) 600 x 260 x 565 mm
23.62 x 10.24 x 22.24 inches
695 x 260 x 565 mm
27.36 x 10.24 x 22.24 inches
Weight 28.8 kg / 63.49 lbs. 33.5 kg / 73.85 lbs.
Accessory Power cable, Footswitch (VFS1), Owner’s manual, Dust cover
Specifi cations and appearance are subject to change without notice for improvement.
43