Yamaha CLP-820S Musical Instrument User Manual


 
66
CLP-880/860/840/820/820S
6 7
240
127
110
220
Cord holder
A voltage selector is provided in some areas.
N
Connect the pedal cord.
Pass the pedal cord through the two cord holders on the side
panel. Plug the free end of the cord into the PEDAL connector
on the rear of the main unit.
M
Voltage Selector
Before connecting the AC power cord, check the setting of
the voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
“minus” screwdriver to rotate the selector dial so that the cor-
rect voltage for your region appears next to the pointer on the
panel. The voltage selector is set at 240V when the unit is
initially shipped.
After the proper voltage has been selected connect the AC
power cord. A plug adaptor may be also provided in some
areas to match the pin configuration of the AC wall outlets in
your area.
Use the vinyl tie that was removed from the bundled pedal cord in
step
C
to tie up any slack in the pedal cord.