Yamaha DG100-212A Musical Instrument Amplifier User Manual


 
13
Speaker Simulator ON/OFF
The DG amplifiers speaker simulator provides the line signal with a realistic
simulation of the natural sound of a speaker. The speaker simulator can be
used on the line signal when the LINE OUT jack is connected to a mixer or
recorder.
1. Press the button for more than 1 second. The “UTIL.” mode
display lamp will light.
2. Press the button. The current setting will be shown on the
display.
3. Use the / buttons to select either “on” or “oF” (ON/OFF).
Set the Volume Pedal Position
Set the position for where control of the volume, via MIDI, will take place.
(Refer to the Using MIDI to Control Volume section on page 11 for more
information on Volume Pedal Position.)
1. Press the button for more than 1 second. The “UTIL.” mode
display lamp will light.
2. Press the button. The current setting will be shown on the
display.
3. Use the / buttons to select the volume control position (bP,
Ap, Ar).
MIDI Transmission/Reception between DG
series amplifiers.
You can use the MIDI bulk out/bulk in functions to copy memory and utility
setup data from one DG series guitar amplifier (DG100-212A/DG80-210A/
DG80-112A/DG130HA) to another.
* Make sure the receiving DG amplifier is in the AMP mode or EFFECT mode.
EX.) Copy the memory from a DG100-212A to a DG130HA.
MIDI Bulk Out
DG100-212A
Rear Panel
MIDI Cable
MIDI Bulk In
DG130HA
Rear Panel
MIDI OUT
MIDI IN
Utility Mode
STATUS
DATA/CTRL
BANK MSB/MAX
BANK LSB/MIN
TOGGLE ON-OFF
/NUMBER OF PGM
DEC
/NO
INC
/YES
MEMORY
EDIT
PC
EDIT
WRITE
/EXIT
±10
8.8.8
.
DG amplifier
Rear Panel
MIDI Cable
External MIDI Device
MIDI IN
MIDI OUT
DG100-212A/DG80-210A/DG80-112A/DG130HA