Filter
Top Products
Sending Channel Signals to Aux Sends 95
01V—Owner’s Manual
Sending Channel Signals to Aux Sends
Signals from input channels 1 through 16 and the effects returns can be sent to aux
sends 1 through 4, while those from input channels 17 through 24 can be sent to aux
sends 1 and 2.
For Input Channels 1–16
1. Use the [AUX] buttons to select an aux send.
The faders now function as channel aux send controls for the selected aux send, and an
AUX page similar to the one shown below appears.
2. Raise the fader of the channel you want to send to the aux send.
If the aux send is configured post-fader (“Pre-fader/Post-fader Aux Sends” on page 97),
you’ll have to raise the channel’s regular fader as well. To do this, press the [HOME]
button, and then raise the fader.
The aux send controls on input channels 13 and 14 (likewise 15 and 16) are perma-
nently linked. When input channels 1 through 12 are paired (“Pairing Input Channels”
on page 52), their aux send controls are linked.
For Input Channels 17–24
1. Use the [OPTION I/O] button to locate OPTION page 2, as shown below.
2. Use [SEL] buttons 17 through 24 to select channels.
3. Use the cursor buttons to select an AUX fader, and the PARAMETER wheel
or [–1/DEC] and [+1/INC] buttons to set the send level.
If the aux send is configured post-fader (“Pre-fader/Post-fader Aux Sends” on page 97),
you’ll have to raise the channel’s regular fader as well. If the Option I/O fader mode is
still selected, simply raise the fader.