Filter
Top Products
6
EMX88S/EMX68S Quick Guide
EMX88S/EMX68S—Owner’s Manual
EMX88S/EMX68S
Quick Guide
The following steps (1–5) explain the basic con-
nection and operation of the EMX88S/EMX68S.
Also, please read “Front and Rear Panel” and
“Basic Operation” following this Quick Guide
section to learn more about using the EMX88S/
EMX68S.
Connection
Connecting speakers
Using speaker cables, connect each speaker to the
SPEAKERS A 1 jack and to the B 1 jack in the
SPEAKERS jack section on the rear panel of the
EMX88S/EMX68S.
• The diagram above shows an example of connecting
two main speakers. Refer to pages 17–18 for other
connection examples.
• You may connect to either of the two jacks on the
speakers.
• Be sure to use a cable designed for speaker connec-
tion.
Never connect the speakers in the manner shown
below. Otherwise, the EMX88S/EMX68S’s built-
in power amplifier will be damaged.
Setting the power amplifier mode
Set the power amp select switch (located on the
right corner on the panel) to MAIN L-R.
• This Quick Guide assumes that two main speakers
are connected. Refer to pages 13, 17, 18 for other
connections and power amp select switch settings.
• When the power amp select switch is set to the
MAIN L-R position, the stereo L signal will be out-
put from the SPEAKERS A jacks, and the stereo R
signal will be output from the SPEAKERS B jacks.
STEP 1
EMX88S (EMX68S)
EMX88S (EMX68S)
EMX88S (EMX68S)
EMX88S (EMX68S)
Power amp select switch