Filter
Top Products
Setup items required when you start up the M7CL for the first time
55
M7CL Owner’s Manual
Connections and setup
4
3
In the To ST PAN/BALANCE field of the
SELECTED CHANNEL VIEW screen, make
sure that the ST button is on (white charac-
ters on a pink background).
In the TO ST PAN/BALANCE field you can use the
ST/MONO button to switch the signal sent from the
input channel to the STEREO/MONO buses on/off.
The knob in this field indicates the pan/balance of the
signal sent to the STEREO bus.
If the ST button is off (black characters on blue back-
ground), press the button to switch it on.
4
Verify that in the top panel, the [ON] of the
corresponding input channel is on.
The [ON] turns the corresponding channel on or off. If
the [ON] key is off (LED dark), press the key to turn it
on (LED lit).
5
In the STEREO/MONO MASTER section,
make sure that the [ON] key of the STEREO
channel is on, and raise the STEREO chan-
nel fader to 0 dB.
1 STEREO channel [ON] key
B STEREO channel fader
6
Raise the fader of the currently selected
input channel to an appropriate volume.
In this state, you should now hear sound from the
speaker system that is patched to the STEREO chan-
nel.
If you don’t hear sound, check whether the LR meters
are moving in the METER field of the function access
area.
[METER field of the function access area]
● If the LR meters are moving
It may be that the STEREO channel is not correctly
patched to the output jacks that are connected to
your speaker system. Check the output port patching
p. 105.
● If the LR meters are not moving
Make sure that signals are being routed correctly to
the patched input channels.
7
To adjust the pan/balance of the signal sent
from the input channel to the STEREO bus,
turn the [PAN] encoder of the SELECTED
CHANNEL section.
When you turn the [PAN] encoder, the knob in the HA
field of the SELECTED CHANNEL VIEW screen
will move in tandem with the encoder.
8
Press the [SEL] key of another input chan-
nel, then repeat the procedure from Step 2.
When you press a [SEL] key to select another channel,
the channel shown in the SELECTED CHANNEL
VIEW screen will change accordingly.
1
2
• The signal being output from the STEREO channel can
also
be monitored using headphones connected to the PHONES
OUT jack located below the front pad
p. 154.
HINT