Filter
Top Products
Front and Rear Panels
Owner’s Manual
16
English
Master Control section
1 Reverb section
This section enables you to set the type, output level,
and other settings for the internal digital reverb.
REVERB [TYPE] switch
This switch determines the type of internal digital reverb.
Each press of the switch cycles through different
effect types in this order: HALL → ROOM → PLATE.
[REVERB TIME] control
This control adjusts the reverb time (duration of
reverberation) of the internal digital reverb. Rotating
the knob counter-clockwise will shorten the duration,
and rotating it clockwise will extend the duration.
REVERB [LEVEL] control
This control adjusts the output level of the internal
digital reverb. The “▼” position corresponds to the
nominal level (0 dB).
[TO AUX]/[TO REC]/[TO ST] switches
These switches route the output signal from the internal
digital reverb to the AUX, REC, or STEREO buses. Turn
the desired switch on ( ) to route the output from the
internal digital reverb to the desired buses.
2 2TR TO ST section
This section enables you to adjust the level of and
route the signal input from the 2TR IN jacks (page 20).
[LEVEL] control
Adjusts the level of the signal input from the 2TR IN jacks.
The “▼” position corresponds to the nominal level (0 dB).
[ON] switch
This switch determines whether the 2TR IN signal will be
sent to the STEREO buses. When the switch is turned on
( ), the 2TR IN signal is sent to the stereo buses.
3 DAW TO ST section
This section enables you to adjust the level of and
route the stereo signal transmitted from the DAW
(DAW IN 1/2).
[LEVEL] control
This control adjusts the level of the stereo DAW
signal to the STEREO buses. The knob set to the “▼”
position corresponds to the nominal level (0 dB).
[ON] switch
This switch determines whether the stereo output signal
from the DAW will be routed to the STEREO buses.
When the switch is turned on ( ), the stereo output
from the DAW will be sent to the mixer’s STEREO buses.
4 STEREO [BAL] control
This control adjusts the left and right volume balance
of the stereo channels (STEREO L/R).
5 [PFL] (Pre-Fader Listen) switch
If you want to monitor pre-fader input channel
signals when you are using the Solo function, turn
this switch on ( ).
6 STEREO [ON] switch
This switch turns on and off the signal output from
the ST OUT jacks. When the switch is on ( ), the
signal is output from the ST OUT jacks.
7 STEREO fader
This fader adjusts the level of the signal output from
the ST OUT jacks. The “0” position corresponds to
the nominal output level (0 dB).
HALL Simulates reverberation in a concert hall.
ROOM Simulates reverberation in a room.
PLATE Simulates reverberation of a plate echo.
1
2
3
4
5
6
7
If you turn on the C-R SOURCE SELECT
[5.1] switch, the DAW TO ST [ON] switch will be
disabled.
While this switch is turned on, if you also
turn the [SOLO] switch on, the monitor signal
volume may become very loud. In this case, use the
[SOLO LEVEL] control (page 17) to adjust the
monitoring volume level. The monitoring volume
level of the n8 is always attenuated by 12 dB.
NOTE
Only
NOTE
Only