Filter
Top Products
10
1
Set to the “0” position.
2 Turn the power on.
3 Select a desired input source.
The indicator of the selected source lights up.
4 Select the speakers to be used.
*
If you use two speaker systems, press both the A and B
switches.
5 Play the source.
6
Adjust to the desired output level.
7 If desired, adjust the BASS, TREBLE and BALANCE
controls or turn on the PURE DIRECT switch. (Refer to
page 12.)
OPERATIONS
TO PLAY A SOURCE
STANDBY/ON
SLEEP
TAPE
MONITOR
PURE
DIRECT
PHONES
SPEAKERS
ON
OFF
AB
ON
OFF
PURE
DIRECT
TAPE
MONITOR
BASS TREBLE BALANCE
LR
0
VOLUMEINPUT
0l0
CDMDTAPE TUNERAUX
––+ +
PHONO
0
NATURAL SOUND STEREO AMPLIFIER AX 9
l
477
2 3 1, 6
Lights up.
VOLUME
0l0
STANDBY/ON
INPUT
CDMDTAPE TUNERAUX PHONO
0l0
VOLUME
SPEAKERS
ON
OFF
AB
ON
OFF
When you finish using this unit
Press the STANDBY/ON switch again to turn this unit into the
standby mode.
Standby mode
In this state, this unit consumes a very small quantity of
power to receive infrared-signals from the remote control
transmitter.