Filter
Top Products
FCC INFORMATION (U.S.A):
IMPORTANT NOTICE FOR THE UNITED KINGDOM
Applies to power adaptor
Connecting the Plug and Cord
IMPORTANT:
THE WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
BLUE: NEUTRAL
BROWN: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured
BLACK .
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured
RED.
Make sure that neither core is connected to the earth terminal of the three pin plug.
IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements.
Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.
IMPORTANT:
When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC
authorization to use to use this product in the USA.
NOTE:
This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B”
digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in
a residential environment will not result in harmful interference with other electronic devices. This requirement generates/
uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause
interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that
interference will not occur in all installations. If this product is found to be the source of interference, which can be
determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following
measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon
lead, change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to
distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha
Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA 90620
MIDI IMPLEMENTATION CHART
YAMAHA Date:10-July-2006
Model: Version:1.00
* For models equipped with a sostenuto pedal.
Function... Transmitted Recognized Remarks
Basic Channel Default 1 1+2
Changed ✕✕
Mode Default 3 3
Messages ✕✕
Altered **************** ✕
Note Number 21-108 21-108
: True voice **************** 21-108
Velocity Note ON { 9nH, v=1-127 { v=1-127
Note OFF { 8nH, v=40H {
After Touch Key s ✕✕
Ch s ✕✕
Pitch Bend ✕✕
Control Change 0, 32 {{Bank Select
1 ✕ { Modulation
7 ✕ { Volume
10 ✕ { Panpot
11 ✕ { Expression
64, 67 {{Pedal
66 ✕ ({*) { Sostenuto Pedal
91 {{Effect Depth
Prog Change {{
: True # ****************
System Exclusive ✕✕
Common : Song Pos ✕✕
: Song Sel ✕✕
: Tune ✕✕
System Real Time : Clock ✕✕
: Commands ✕✕
Aux : All Sound OFF {{ (120, 126, 127)
: Reset All Cntrls ✕ { (121)
: Local ON/OFF ✕ { (122)
: All Notes OFF ✕ { (123-125)
Messages : Active Sense {{
: Reset ✕✕
Notes
Mode 1 : OMNI ON. POLY Mode 2 : OMNI ON. MONO
Mode 3 : OMNI OFF. POLY Mode 4 : OMNI OFF. MONO
{:Yes
✕:No