Filter
Top Products
9
Power Supply
The Silent Guitar operates either on battery power or with an AC adaptor however,
it will consume more power when the reverb function is in use. For that reason, we
recommend that it be powered with the supplied AC power adaptor for normal use.
Always turn the PHONES ON/OFF switch OFF before making AC power connec-
tions or replacing the battery.
When battery power becomes low, the reverb will no longer operate, the lamp will not light and noise will
be present. Replace the battery with a new alkaline battery as soon as possible.
• Always follow the +/– signs when inserting the battery. Improper insertion may result in fire.
• To prevent possible damage to the unit due to battery leakage and unnecessary power drain, remove
the battery from the unit when it is not going to be used for an extended period of time.
■ Supplying AC Power
1. Plug the adaptor’s DC output cable into the Silent Guitar’s DC IN jack, making sure the plug is firmly
inserted into the jack.
2. Plug the AC adaptor into a convenient wall AC power socket.
• Battery power is automatically disconnected when the AC adaptor is connected.
• When the AC adaptor is used, the batteries may leak. To prevent leakage we recommend that you remove
the batteries from the instrument. When the AC adapter is used.
• When using an AC adaptor, make sure you use only one of the following recommended adaptors (Recom-
mended Adaptors: PA-D09, PA-1E, PA-3C). The use of any other adaptor may result in damage to the
instrument or cause fire, etc. Please use with caution.
Bij dit produkt zijn batterijen geleverd.
Wanneer deze leeg zijn, moet u ze
niet weggooien maar inleveren als KCA.
■ Installing the Battery
1. Be sure to use a 9-volt alkaline battery 6LR61. (not
supplied)
• When using a battery, please use an alkaline bat-
tery. Use of a manganese battery will result in an
extremely shorter battery life depending upon the
type of battery used.
2. Remove the battery compartment cover, located on
the back side of the Silent Guitar, by sliding the tab
labeled “OPEN” toward the head of the guitar.
3. Attach the 9-volt battery 6LR61 to the battery snap,
and place it in the battery case.
Take careful note of the polarity markings (+/-) as
shown in the illustration when connecting the bat-
tery. (Reversed polarity may damage the circuit.)
4. Close the battery compartment cover.
6LR61 9V
Alkaline battery
Battery compart-
ment cover
Battery snap
* For customers in Netherlands
02_slg100s_en.pm65 06.8.22, 11:05 AM9