Filter
Top Products
53
■ CHANGING A PATTERN - After recording a song, you can go back and change
a pattern at any time. First, in Song Record Mode, locate the measure of the
pattern you want to change, by pressing [FWD] and [BWD]. Next, select the
new pattern by pressing [-1] and [+1].
■ CHANGING A BACKING - As you record song parts by selecting and entering
patterns, the backings which are assigned to the various patterns will also be
recorded in the song. Although you cannot change a backing in Song Record
Mode, there is in fact an easy way to change the backing. First, enter Pattern
Mode and access the pattern Copy function and copy the pattern to a User
pattern location. Next, assign the different backing to it (see “ASSIGNING A
BACKING TO A USER PATTERN”, page 34). Then, return to Song Record
Mode and follow the procedure outlined above in “CHANGING A PATTERN”.
■ EXCEEDING THE MAXIMUM NOTE POLYPHONY - The RY8 has 28-note
polyphony, which means the maximum number of notes that can sound at
one time is 28. Depending on the song you have created, several drum beats
may fall on a specific location where many bass and chord notes exist. Any
drum beats that would exceed the 28-note capacity will be “truncated”, or cut
off, or will not play.
Turning the power off while Song Record Mode is active, or while the song Copy or Clear function
is being executed, may cause the irretrievable loss of all User data.
The pattern and chord tracks are independent! You can only insert a chord by part, and not event.
When inserting a chord, the succeeding parts will be moved back by one part. Therefore, take care
that your chord insertions don’t alter your song structure in relation to the pattern track.
■ EXITING CHORD ASSIGN - To exit the Chord Assign feature, press
[CHORD] again.
If you attempt to enter a chord change and the message “PART EMPTY” appears in the LCD, this
means that there is no pattern data in the track.
CAUTION