Zoom G1U Guitar User Manual


 
6
ZOOM G1u
7
ZOOM G1u
Selecting a Patch for Playing (Play Mode)
Selecting a Patch for Playing (Play Mode)
Bank
name
Patch
number
MN
MN
The volume control on the connected amplifier
should be turned down.
When using the unit on batteries
Plugashieldedcableintothe[INPUT]jack.
When using the unit with an AC adapter
Plugthecablefromtheadapterintothe[DCIN]
jack.
Turntheguitaramplifieronandadjustthevolumeto
a suitable position.
If the G1u is connected to a computer via a USB cable,
and the AC adapter is not connected, power will be
supplied via the USB port.
Set the Module selector to "PLAY".
The bank and patch number are shown on the display.
Immediately after turning the G1u on, the unit will be in
play mode, regardless of the position of the Module
selector.
Turn power on
1
Set the G1u to play mode
2
Directly switch a bank
4
Adjust the master level
5
Press the [BANK UP·TAP] key.
The unit cycles through banks in the order A ... J,
0...9,A.
You can also use an external foot switch (FS01) to
switch banks (
g
p. 18).
Operate the [VALUE] knob.
The master level setting appears on the display.
The master level setting applies to all patches. The
settingrangeis0–98,1.0.Itwillberesetto80when
power is turned off and then on again.
When using headphones, this knob adjusts the listening
volume.
Select a patch
3
Use the foot switches.
Press the [
Q
]footswitchtocallupthenexthigher
patch.
Press the [
W
]footswitchtocallupthenextlower
patch.
The unit cycles through patches in the order
A0–A9...J0–J9
g
00–09...90–99
g
A0.
This section explains basic functions of the play mode.
HINT
HINT
HINT
HINT
80
A0 B0
A0 A1
A0 99