24 CHAPTER 2: INSTALLING THE SWITCH
Figure 5 Fitting a Bracket for Rack-Mounting
3 Insert the two screws and tighten with a suitable screwdriver.
You must use the screws supplied with the mounting brackets. Damage
caused to the unit by using incorrect screws invalidates your warranty.
4 Repeat step 2 and step 3 for the other side of the Switch.
5 Insert the Switch into the 19-inch rack and secure with suitable screws
(not provided). Ensure that ventilation holes are not obstructed.
6 Connect network cabling.
7 Finally place a unit information label on the unit in an easily accessible
position. The unit information label shows the following:
■ 3Com product name of the Switch
■ 3Com 3C number of the Switch
■ Unique MAC address (Ethernet address) of the Switch
■ Serial number of the Switch
You may need this information if you contact 3Com Technical Support.
10014914AA.book Page 24 Friday, July 7, 2006 2:08 PM
