28 C
HAPTER
3: M
ANAGING
D
EVICES
■
Temperature — Allows you to view temperature information for a
chassis.
■
Fabric — Allows you to view information for the Gigabit Ethernet
(GEN) Switch Fabric Module (or modules) operating in the chassis.
Module Management
To manage CoreBuilder 9000 Switch modules:
1
View the front of the chassis by starting Device View.
2
Highlight the module and click the right mouse button. Device View
displays a shortcut menu. The menu options include the following:
Configure Module
and
Configure Bridge
(all modules), and
RAP
and
IP
Config
(Layer 3 modules only).
a
If you select
Configure Module
, Device View displays the
Config
Module
section, which includes the
Reset
, VLANs, and
Backplane
Connections
(switch fabric module only) tabbed pages. Refer to
Module Settings for information on these pages.
b
If you select
Configure Bridge
, Device View displays the
Bridge
section,
which includes the
General
and
Spanning Tree
tabbed pages. Refer to
Bridge Settings for information on these pages.
c
If you select
RAP
, Device View displays the
RAP
(Roving Analysis Port)
section, which includes the
Analyzer Setup
and
Monitor Setup
tabbed
pages. Refer to RAP Settings information on these pages.
d
If you select
IP Config
, Device View displays the
IP Configuration
section, which includes the
ARP Cache
,
Interfaces
, and
Routes
tabbed
pages. Refer to IP Configuration Settings for information on these
pages.
3
Click
Apply
after making changes to any settings.
Module Settings
The
Config
Module
section contains the following tabbed pages:
■
Reset— Allows you to reboot a module. Rebooting a module
disconnects any rlogin and telnet. It also temporarily disrupts your
ability to poll the module using Transcend applications, and the
module shows up as unreachable.
■
VLANs — Show the VLANs currently defined on the module and
enables you to create new VLANs, or modify or delete existing VLANs.
