3 - 30 Ethernet RMON MultiProbe Module Installation and Operation Guide
To configure other interfaces, use the Modify/View Network Settings
configuration menu to change the BOOTP network interface.
BOOTP Requirements
The BOOTP server must perform the following functions:
❑ Map hardware addresses to IP addresses
❑ Respond to BOOTP requests from clients
❑ Support the vendor-specific subnet mask and default gateway fields
Using BOOTP
To use BOOTP, add the following information to the BOOTP server
bootptab configuration file:
❑ MAC address - Hardware address of the RMON MultiProbe Module
interface to be configured
❑ IP address - IP address for the module interface
❑ Subnet mask - Subnet mask for the module interface
❑ Default gateway - Default gateway for the RMON MultiProbe
Module
For additional information on BOOTP configurations, refer to your server
documentation.
Sample BOOTPtab file
A sample bootptab file is shown on the next page. If necessary, create this
file on the BOOTP server.
