Assemble a shoulder bolt (L) and a 3/8" washer (T) to
the outside of R.H. side plate, securing it with a 3/8"
fl anged nut (X). Repeat for L.H. side plate.
5/16"
NYLOCK
NUT (Y)
5/16" x 1"
CARRIAGE BOLT (J)
ENGINE MOUNTING
PLATE
(4) 1/2" WASHERS (R)
(3) 3/8" FLANGE NUTS (X)
(3) 3/8" x 1"
CARRIAGE
BOLTS (G)
SEE NOTE
3/8" WASHER (T)
SHOULDER
BOLT (L)
3/8" FLANGED
NUT (X)
Fasten the R.H. Side Plate (bend facing out) to the
front three holes in the tractor frame using three 3/8"
x 1" carriage bolts (G), three 1/2" washers (R) (see
note) and three 3/8" fl ange nuts (X).
use a 5/16" x 1" carriage bolt (J), a 1/2" washer (R)
and a 5/16" nylock nut (Y).
Place the 1/2" washers (R)
between the tractor frame and the side plate. Repeat
Reinstall the browning shield onto the tractor frame
using the original screws.
If there is an engine mounting plate (shown with
dotted lines) leave the 1/2 washer off the bolt that goes
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
Remove the bolt, if present, in the hole directly behind
the brake rod on the left side of the tractor frame.
Attach the L.H. Hanger Bracket (tube facing out) to the
hole using a 5/16" x 3/4" self threading bolt (F).
• Install a round head shoulder bolt (M) into the hole
that is 9-1/2" to the rear of the bolt you just installed.
Secure it with a 3/8" fl ange nut (X) on the inside of the
5/16" x 3/4" SELF
THREADING BOLT (F)
L.H. HANGER
BRACKET
BRAKE ROD
3/8" FLANGED
NUT (X)
SHOULDER
BOLT (M)
5/16" x 3/4" SELF
THREADING BOLT (F)
R.H. HANGER
BRACKET
RIGHT END OF
BRAKE ROD
3/8" FLANGED
NUT (X)
SHOULDER
BOLT (M)
Remove the bracket, if present, from the hole directly
behind the end of the brake rod on the right side of
the tractor frame. Store the bracket and bolt.
Attach the R.H. Hanger Bracket to the hole using a
5/16" x 3/4" self threading bolt (F).
• Install a round head shoulder bolt (M) into the hole
that is 9-1/2" to the rear of the bolt you just installed.
Secure it with a 3/8" fl ange nut (X) on the inside of the
