11
Audio connections (Gold only)
On the X2 Gold REMOTE module, audio connections are available at the two
3.5” jack sockets mounted on the side (same side as the switch bank). Note:
The microphone input (labelled ) has a dual function whereby it can either
support a mono-channel microphone or alternatively receive stereo line input.
Switch 3 on the LOCAL module controls the setting of this port: LOCAL switch 3
OFF - microphone, LOCAL switch 3 ON - stereo line in.
1 Connect the microphone
(or stereo line input) plug to
the REMOTE module socket
labelled .
Note: Ensure that the
setting of switch 3 on the
LOCAL module matches the
input to this socket:
OFF-microphone;
ON-stereo line input).
2 Connect the speaker plug
to the socket labelled .
Note: When the X2 Gold REMOTE module
is rack mounted, the audio connections
must be made after the module has been
xed in place. Access is required to the
rear and above the rack. Remember to
remove the audio connections before
attempting to slide out the REMOTE
module.
Microphone (or
stereo line-in)
connection
Speaker
connection
