34
Fitting under a counter (kitchen worktop or sink)
By removing the machine’s worktop, you can install
it under a close fitting sink unit or a pre-existing
top, providing the dimensions of the recess
correspond to those shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by unscrewing
the two front retaining screws, pull from the
front and slide out the rear slots, lifting the
worktop.
Insert the machine after adjusting height and levelling with the adjustable feet.
When inserting the machine, ensure that the water inlet and drain hoses are not
kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the levelling
spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until the
machine is perfectly level.
Installation
820
570-600
450
IN04
152976 12/1en 27-05-2002 11:45 Pagina 34
