18 Rev 0.0
INSTALLATION INSTRUCTIONS
EN
5.2.1.1 Connecting to the water tap
Connect the inlet hose to a threaded ¾” gas cold water tap, tting the supplied
lter (ref. A g. 5-06). Firmly secure the hose by tightening the relative ring nut
with your hands (ref. B g. 5-06); nish by tightening another ¼ turn using a
pair of plumbing pliers. For models tted with ACQUASTOP (ref. C g. 5-06)
the lter is already present in the threaded ring nut.
The dishwasher can be lled with water at a temperature of less than 60°C
(140°F).
If the appliance is lled with hot water, washing times will be reduced by about
20 minutes, but e ciency will be slightly impaired. Make the connection to the
domestic hot water tap using the same methods described for connecting the
appliance to the cold water tap.
Recommended temperature: 49°C (120°F), max. 60°C (140°F). •
Recommended water pressure: 0.5 - 9 bar (7 -130 PSI). •
If the pressure is too high,
t a pressure reducer.
A rubber hose connected to a sink spray may burst if installed on the same
pipes feeding the dishwasher. If your sink is tted with this accessory, re-
move the hose and plug the hole.
Fig. 5-06
