30 User's Guide Fastmark 6000 Series
Resetting the Printer to Factory Default Settings
To reset the printer to its factory defaults after certain commands have been sent or settings
changed:
1. Power off the printer.
2. Press and hold the CANCEL/RESET button.
3. Power on the printer.
4. As the printer turns on the printer will:
The printer will display “E2PROM RESET …” on the LCD and the READY
LED will blink.
5. When the “READY” LED stops blinking and the Display indicated "READY"
on the LCD the printer's initialization is completed.
6. The following parameters reset to Factory Defaults.
- Label parameters
- Heat (Darkness)
- Speed
- Symbol set (language)
- Others for specific emulation
Notes:
1. All settings stored in non-volatile E2PROM are not erased when the printer looses
power.
2. Mechanical positions of the Switches on the back will not be changed with this
procedure.
3. It is necessary to do a Label Sensor Calibration following a Reset.
4. The label count printed during the Self-Test can not be reset.
