6
3. Find a 4-pin molex or SATA connector on the power supply and connect it to
the power connector on the device.
Cooling System
The 120mm TriCool™ fans
The Fusion 430 comes with two 120mm TriCool™ fans preinstalled at the side of
the case inside the motherboard chamber. These two fans are preinstalled at the
side of the case next to the CPU for effective CPU cooling and have a three-speed
switch that allows you choose between quiet, performance, or maximum cooling
(Please see specifications below). The fans are installed so that the air is blowing
out of the case. Connect 4-pin connectors from the power supply to the 4-pin connector
on the fans.
Note: The minimum voltage to start the fan is 5V. We recommend our users to set
the fan speed to High if you choose to connect the fan to a fan control device. A
fan-controller regulates the fan speed by varying the voltage to it. The voltage may
start as low as 4.5V to 5V. Connecting a TriCool™ fan set on Medium or Low to a
fan-control device may result in the fan not being able to start.
Specifications:
Size: 120 x 120 x 25.4mm TriCool™ Fan
Rated Voltage: DC 12V
Operating Voltage: 10.2V ~ 13.8V
The Bottom Air Intake
There are intake vents at the bottom of the case right under the HDD chamber.
Cool air will flow into the vents through the hard drives, and then flow into the
motherboard chamber and exhaust by the two 120mm TriCool™ fans.
Note: Do not place the Fusion v2 on a soft surface or over anything that will block
the bottom air vents.
The Upper Air Intake
There are vents on the top panel above the PCI expansion slot. Cool air will flow
through it into the motherboard chamber to cool the VGA card.
Note: Do not place anything on top of
the Fusion 430 that will block the top air vents.
The Rear Air Intake
There are vents right above the rear I/O panel and on the PCI expansion slot covers
to bring in cool air to the CPU and VGA card.
CPU Air Guide
Speed Input
Current
Air Flow Static
Pressure
Acoustical
Noise
Input
Power
High
2000 RPM
0.24A
(Max.)
2.24 m³ / min
(79 CFM)
2.54 mm-H
2
O
(0.10 inch-H
2
O)
30 dBA 2.9 W
Medium
1600 RPM
0.2A 1.59 m³ / min
(56 CFM)
1.53 mm-H
2
O
(0.06 inch-H
2
O)
28 dBA 2.4 W
Low
1200 RPM
0.13A 1.1 m³ / min
(39 CFM)
0.92 mm-H
2
O
(0.04 inch-H
2
O)
25 dBA 1.6 W
