‐2‐
General Safety Rules
WARNING: When using this tool, basic safety precautions should always be followed to reduce the
risk of personal injury and damage to equipment. Read all warnings and instructions before using
this tool.
• Always wear ANSI approved safety goggles and ear protection when working with tools and
equipment.
• Observe work area conditions. Keep work area clean. Cluttered areas invite injuries. Do not use
tool in damp or wet locations. Don't expose tool to rain. Keep work area well lighted.
• Keep children away from work area. Do not let them handle tool.
• When not in use, tool must be stored in a dry location to inhibit rust. Always lock up tool and
keep it out of the reach of children.
• Do not force tool. It will do the job better and more safely at the rate for which it was intended.
Do not use inappropriate attachments in an attempt to exceed the tool capacity.
• Use the right tool for the job. Do not modify this tool and do not use this tool for a purpose for
which it was not intended.
• Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts.
Non-skid footwear is recommended when working. Wear restrictive hair covering to contain
long hair.
• Do not overreach. Keep proper footing and balance at all times. Do not reach over or across
running tool.
• Maintain tool with care. Follow instructions for lubricating and changing accessories. Inspect
tool periodically and, if damaged, have them repaired by an authorized technician or replaced.
• Do not operate any tool when you are tired or under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate the tool.
• Check for damaged parts. Before using any tool, any part that appears to be damaged should
be carefully checked to determine that it will operate properly and perform its intended function.
Any part that is damaged should be properly repaired or replaced.
• When servicing, use only identical replacement parts. Use of any other parts will void the
warranty. Only use accessories intended for use with this tool.
• Maintenance. For your safety, service and maintenance should be performed regularly by a
qualified technician.
NOTE: The warnings and cautions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product, but must be supplied by the operator.
