User Guide P. 3
Remote-starting Your Vehicle
Setting Your Vehicle Into Ready Mode
In order to start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is
not set to Ready Mode, it cannot remote-start the vehicle.
Once the system is set to Ready Mode, the vehicle can be remote-started and stopped at
wish.
To set the system to Ready Mode:
1. Ensure that all the doors are closed and that the shifter is in the NEUTRAL position.
2. With the engine already running, apply the parking brake and release the brake
pedal.
• Make sure to release the brake pedal.
3. Within 20 sec. press Ι or ΙΙ on the transmitter.
• The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a. ΙΙ to shut down the engine without affecting the doors.
b. Ι & ΙΙ to lock the door and activate idle mode.
NOTE: If button Ι is programmed as LOCK or UNLOCK, press and hold either
a. Ι to lock the doors and shutdown the engine or lock and enter turbo mode,
b. ΙΙ to shut down the engine without affecting the doors,
c. Ι & ΙΙ to lock the doors and activate idle mode.
Remaining In Ready Mode
Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However,
should any of the following occur, the vehicle will exit Ready Mode – thus eliminating the
remote start option until Ready Mode is restored:
• Door opened;
• Hood opened;
• Brake pedal pressed;
• Parking brake disengaged;
• Ignition key turned to the IGNITION ON (RUN) position.
Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes
(parking lights).
Remote-starting
Press the Ι button for approx. 1 second. The parking lights will come on, informing you that
the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking
lights will remain
ON during the pre-programmed run time.
If the vehicle doesn’t start the first time, the system will shut down.
Driving Off
Enter the vehicle and do the following:
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Note: Press button Ι to
DISARM the module and to UNLOCK the doors (if button Ι is
programmed as
LOCK or UNLOCK button).
