User Guide P. 13
Diagnostics – Parking Light Flash Table
Flashes Description
1
• Doors locked, starter kill armed
• End of run time
•
TRUNK button pressed
• Start signal received by the module
• Cold weather mode cancelled
2
• Doors unlocked, starter kill disarmed
• Run time cancelled
• Remote start attempt cancelled by remote
• Exiting remote valet
• Exiting ignition valet
3
• Entering cold weather mode.
• Entering extended run time.
• Entering remote valet
• Entering ignition valet
4
• +12 V where detected on the brake line and cranking was cancelled.
• Entering tach-programming mode
5
• New transmitter programmed.
• Tach programmed.
6
• A remote start was attempted while a tach or a vacuum signal was detected
before cranking.
8
• Unit reset: occurs when the unit is reset to the factory defaults.
10
• The hood switch line went to ground during cranking or run time.
1 – pause – 2
• There was an attempt to start the vehicle while the module was in valet
mode.
ON solid
• Cold weather mode: the brake pedal is being held down.
2 – pause – 2
• There was an attempt to start the vehicle while the module was in home valet
mode.
ON 2 sec.
• The hood is up and the hood switch line went to ground. This is step one of
the programming centre procedure.
ON 3 sec.
• First press of the
START button under safe start.
ON 4 sec.
• Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 25 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for
20 seconds.
• Or the unit went into step 1 of the transmitter programming procedure and no
activity was detected for a few seconds. The unit has exited the transmitter
programming procedure.
Irregular
• If the unit gives irregular signals (1 to 10 flashes followed by a pause,
followed by further flashes), the system is playing back start failure codes.
This occurs when the hood pin-switch is pressed three times
Constant
flashes
up to 25 sec.
• Panic mode is triggered.
